KPLUS MOLD JAPAN Co.,LTD.
2-3-7 Honjyo, Higashi-Osaka-City, Osaka, Japan.
|PR message||We can make the mold of preventing defects and non maintenance by utilizing cutting-edge technologies such as 3D metal printers and flow analysis.
In addition to mold sales, we can also sell gas venting inserts GASEXIT and 3D cooling inserts using 3D metal printers.
|The Main Item||
GAS Venting Insert
|The name of Item||GAS Venting Inserts(GASEXIT RUNNER)|
GASEXIT RUNNER is an insert that discharges gases laterally between the P/L surface and the plate.
Given that it is only a Φ10~Φ15 machining on pockets and grooves, it is a low-cost, easy-to-use Mold Venting measure for existing dies.
|The name of Item||GAS Venting Inserts(GASEXIT EP)|
GASEXIT EP is an ejector pin that discharges gas from the releasing part of the ejector pin hole normally machined.
It is a product that can be easily used as a Mold Venting measure because it only has to be replaced in stead of the existing ejector pin.
It can also be installed on the cold slug part where injection pressure is high.
|The name of Item||GAS Venting Inserts(GASEXIT BUSH)|
GASEXIT BUSH is a sprue bush / sprue lock bush that discharges gases from the sprue end part.
Isn't there a large amount of gas tar stuck to the sprue bush during mold maintenance?
This is because the gas accumulated in the nozzle is exhausted outside the mold from the gap between the bushes.
However, the gas tar will stick to the gap between the bushes after production has been done for a while, causing the gas to flow into the product surface, generating product defects.
GASEXIT BUSH is a product that can most efficiently discharge the gases accumulated in such nozzles.
A. MOLDS, MOLD MATERIALS
M. PROTOTYPE, MODELING, 3D PRINTING
Metal Molding Machine